Put a unit here, a sulfur guard or trace pollutant control there or a waste incinerator/converter or....

Go ahead!

• Put that sulfur guard/ device for emission control or for feed gas treatment
• Put it at well mouth or along distribution lines
• Put out a flare/ waste streams converter for profit and environment
• Install a Mercury emission control to your sludge/ waste incinerator
• Install a Trace/ carcinogen controls to meet environmental regulation
• Install a GTL unit at well mouth, remote island/location or on shipboard
• Carry out retrofit, revamp or upgrade you have postponed
• Revive troubled/ idled units
• Minimize over- or under-designs

It should cost far less than you think and Difrex can help.

Absorber/Desulfurizer: We offer reliable design tools and guidance to promptly and inexpensively build, install or upgrade that pollutant absorber or Desulfurizer - catalytic, non-catalytic or mixed using a packed, moving, fluidized bed (BFB or CFB) or a dual-bed (reactor-Regenerator pair). With rising environmental concerns, time is now to do it. We also offer a fluidized bed hot gas Desulfurizer (using zinc titanate absorbent) design model for high-temperature Desulphurization helping energy saving by direct heat recovery (without sulfur corrosion) from high-temperature waste gas.

Burner/Incinerator: We are familiar with all key design aspects of burner/ Combustor chambers and various spray nozzle designs for liquid/ gas/gel fuel and oxidant injections for most efficient mixing and combustion. We are also familiar with the design principles of solid and liquid wastes and sludge incinerators and all auxiliary control/ capture devices/ methods for minimum environmental pollution. We are ready to take the challenge of meeting increasingly stricter pollution standards and as new entries populate the list of environment and health hazards.